Roof Step Flashing

Protect vulnerable areas of your roof against the elements.

Related To:

Weather is a relentless bully. It seems to focus its stormy strength on a home's most vulnerable areas, attacking over and over again until rain and moisture infiltrates, and eventually damages, the home. Because a home's roof takes the brunt of the attack, it's critical to protect vulnerable areas of the roof against the elements, especially rainfall.

The best practice for protecting these vulnerable areas against rain and moisture intrusion is to use step flashing integrated with the shingles. The term flashing refers to both a material as well as a process. You can find flashing materials made of plastic, roofing felt and rubber, but your best bet is rust-resistant metal, either galvanized steel, aluminum or copper. The process of installing the flashing requires close attention and is a critical element to ensuring proper water management of the roof.

The key elements of the process include:

  • Lay an ice-and-water shield to the edge of the roof deck.

  • Place felt paper underlayment on the roof deck, ensuring the underlayment turns up at the sidewall a minimum of three inches.

  • Starting at the bottom of the roof, install kick-out flashing, and then place the first course of the shingles over top of the flashing. Kick-out flashing is a piece of flashing that hangs over the edge of the roof, helping to divert water away from the adjacent wall or around any obstacles that the roof may butt into.

  • Next, install the step flashing, with the next course of shingles over top of it. This process will continue up the entire roof. Step flashing needs to turn up a minimum of three inches up the sidewall. The flashing material should be 4 inches by 7 inches in length when it lies on the roof deck. The 7-inch length ensures a 2-inch headlap on each course.

  • Once complete, the housewrap should overlap the step flashing that's applied to the wall.

  • Wall cladding comes next, with a minimum reveal between cladding and roofing of one inch.

Layering flashing in a shingle-fashion is a critical part of the process. Because wind-driven rain will stop at nothing to infiltrate the home, you have to plan for weather to win out at times and for water to get past the wall's siding system. The flashing underneath the housewrap acts as a second barrier, so any water that gets past the siding is diverted back onto the roof, where it can flow down and away from the home.

Next Up

Weatherproofing the Roof

Peel-and-stick underlayments provide years of protection.

Roofing Component Basics

Roofing terminology can be a bit overwhelming. These basic roofing definitions will help get your project off on the right foot.

5 Ways to Provide Built-In Hurricane Protection

Learn how to protect your home in harsh weather with upgrades and retrofit solutions.

Repairing Roof Damage

A homeowner wants to know the cost of repairing a hole caused by moisture from a damaged roof.

Protecting Plaster

The walls in this home are four bricks thick, with plaster on the inside walls. The homeowner is concerned about moisture damage to the walls, where water may have soaked through after a heavy rain

Roofing Needs Require Some Math

To determine the pitch of the roof, measure over on a level line 12 inches from the edge of the roof on any part of the roof and measure vertically to see what the rise is.

Roofing Rules

Remember two simple codes for new shingles.

Exterior Flashing Keeps Out Water

Flash and seal exterior openings to prevent water intrusion and damage.

Make Your Home Winter Ready

Follow these steps to prep your house for cold winter weather.

How to Repair a Damaged Roof

We simulated the damage of a tree falling on a roof by dropping a piano from a crane. Such an accident can cause major structural damage. Consult a professional if there are any reframing needs due to building codes.

Go Shopping

Refresh your home with stylish products handpicked by HGTV editors.

Follow Us Everywhere

Join the party! Don't miss HGTV in your favorite social media feeds.