Sealing Building Penetrations

Learning how to properly seal building penetrations will help reduce utility bills, prevent drafts and stop the infiltration of moisture.

Related To:

The vents and pipes that penetrate exterior walls and the roof bring the power, water and gas lines into a house, but they can also bring in drafts, mold and wood rot. Ignoring these breaks in a building's thermal barrier threatens the durability of the house and the health of its occupants.

Knowing where these penetrations are and how to seal them makes it possible to reduce utility bills, prevent drafts and stop the infiltration of moisture and all the problems that come with it. The "best practice" is simple, and often overlooked. Flashing, an insulating expanding foam, or in some cases, caulk, can be used to seal these penetrations and prevent the problems.

The penetrations into the home that are likely to cause the most damage are the ones in the roof. Vent pipes are the most prevalent penetration into the building envelope. They are necessary for proper drainage in the plumbing system of the home and their presence will not cause problems if properly sealed. There are two types of flashing that can be used for this purpose: sheet metal cones that can be caulked to the pipe itself or self-sealing types with rubber gaskets.

Once the new shingles reach the base of the vent pipe:

  1. Cut the roofing to fit around the pipe.
  2. Install the flashing over the pipe so that its base flange lies on top of the roofing on the down-side slope.
  3. Continue roofing over the flashing, cutting the shingles to fit around it.
  4. Finally, a vent pipe collar is slid over the pipe.

Next Up

Installing Spray Foam Insulation to Boost Your Home's Air Quality and Energy Efficiency

Improve your home's energy efficiency with spray foam insulation. Learn about the difference between open-cell and closed-cell, the cost of spray foam insulation and whether it's a good DIY project.

Air Sealing the Home Garage

Learn how to keep harmful fumes from spreading into your home with simple steps.

SIPs: Structural Insulated Panels

Frames prove stronger and more energy efficient than conventional stud frames.

Ladder Framing Allows Better Insulation

Increase space for more insulation by reducing the amount of wood needed.

Sealing a Home's Air Leaks

Improve energy efficiency and health by reducing air leakage.

How to Stop Interior Drafts

Learn how sheathing behind tubs, showers and the fireplace can eliminate energy-sapping drafts.

Attic Ventilation

Proper ventilation helps water vapor to exit the attic, helping to dry out existing moisture.

House Wrap: Air Sealing and Protection From the Elements

Use house wrap when framing a home to block out moisture and unwanted air.

Insulated Concrete Forms

Insulated concrete forms (ICFs) offer several advantages: energy efficiency, safety and soundproofing.

Installing Fiberglass Batt Insulation

Use these tips and techniques to ensure proper installation of fiberglass insulation.

Go Shopping

Get product recommendations from HGTV editors, plus can’t-miss sales and deals.

Follow Us Everywhere

Join the party! Don't miss HGTV in your favorite social media feeds.