How to Sculpt a Flying Pig
Fred Conlon welds a variety of metal pieces to create his Flying Pig metal sculpture.
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Fred Conlon' Flying Pig best reflects his sense of humor and tenacity — his friend said Conlon would realize his dream of opening a pottery shop "when pigs fly."
Materials and Tools:
spent fuel canisters
drill bits for pig's feet
templates for ears and wings
nuts and blots
MIG welding equipment
face shield, eye and ear protection
1. Drain any remaining fuel from the spent fuel canister (pig's body) and clean it thoroughly.
2. Trace wing and ear templates with a paint pen onto sheet metal. Cut out the pig ears and wings from the sheet metal using a plasma torch. Be sure to wear leather safety gloves and a welding shield.
3. Weld the ears onto one end of the canister.
4. Weld telephone bells on below the ears to create the eyes.
5. Cut a 2-inch piece of pipe for the pig's snout with a plasma cutter.
- On the side of the pipe, cut out an arch from top to bottom, leaving the bottom ends attached and pull the top of the arch away from the pipe, bending it out to create the mouth.
- Cut a circle the same diameter as the pipe out of sheet metal and cut out two oval holes in the center for nostrils.
- Spot-weld the nostril metal piece to the end of the pipe.
- Weld the pipe on the face below the eyes.
6. Weld four mattress springs onto four drill bits for the legs and feet. Weld the completed feet onto the bottom of the canister.
7. Cut and bend the pig's tail from a steel rod. Weld the tail onto the other end of the canister at the top.
Make intricate shapes and miniatures with clay to create "The Poet."
Valerie Tremelat of Minneapolis is a law clerk by day but she loves to make jewelry.
If you have a passion for fashion, this little black dress ornament is great for dressing up your Christmas tree. Follow these...