Five-Rectangle Knitted Sweater

Alternate Design

We couldn't resist. Even though knitting isn't always too fascinating to watch on television, this cute and easy sweater that knitter Lynne Foster designed was too tempting not to feature it on the show. The sweater is cute enough that any knitter who knows a young baby would be tempted to make one of these, and it is also so easy that it makes a perfect project for a first-time knitter to try. The trickiest part is sewing it together.

You will knit five rectangles--two for the front panels, two for the sleeves, and one for the back...although the back may turn out to look more like a square.

I used a fine two-ply yarn for one sweater, a soft and fluffy baby yarn called Snowflake for another, and a slightly lumpy type of yarn for a third, although this also was of a two- ply weight. All baby sweaters were knit on the same size (#9) needles, but the finished size of the rectangles varied slightly. Using a two-ply yarn with size #9 needles will result in a jacket approximately 9 inches wide by 10 inches long.

Either the garter stitch (k all rows) or the stockinette stitch (k one row, p one row) can be used. I used the garter stitch on all of my sweaters. Lynne used the stockinette stitch.

Steps:

1. For the back: Cast on 32 sts and knit for 10 inches.

2. For the front panels (make two): Cast on 16 sts. and knit for 10 inches.

3. For the sleeves (make two): Cast on 26 sts. and knit for 6 inches.

4. Sew together as follows: Place the two front panels on top of the back piece, lining up the shoulders and the sides. Place the sleeves on the table top so that the stitches are running horizontally as you knit them. Give each panel a quarter turn and fold it in half lengthwise (horizontally).

Position each sleeve so that the folded edge is even with the shoulder (top edge) of the "sweater". This is just to visualize how everything will go together.

5. Remove one of the front panels and the two sleeves. Sew the top edge of the back piece and the top edge of the remaining panel together, starting in the center and sewing to the outside edge. This will be the shoulder seam.

The portion of the front panel that was not stitched can later be folded back for a little lapel if you wish.

6. Fold the front panel back so it is flat on the table top.

7. Pick up one of the folded sleeve pieces and place it in position with the folded edge lined up with the shoulder seam. Unfold it so that the entire end of the piece is lined up along the edge of the sweater. Sew the two pieces together.

8. Fold the front panel back into position. This will also fold the sleeve into position. Sew the bottom seam of the sleeve together.

9. Sew the bottom portion of the sweater front and back together, sewing from underneath the arm to the bottom edge.

10. Repeat the above steps on the other side of the sweater.

Note: The kind of yarn used will not only make the sweater look different but will slightly change the size. For a much larger sweater, I used size #13 needles with heavy chenille yarn. Whatever size you make, just be certain that the back and the two front panels are all the same length.

A few suggestions to change the look of the sweater:

Note: The kind of yarn used will often make the difference as to whether you might want to try one or more of these ideas:

• Crochet around the sweater with the same or contrasting yarn