How to Build a Column with Molding

Cover an ugly pole with an elegant column trimmed with molding.

Materials and Tools:

HRIPR-110_ColumnAfterCROP

The molding on this box column gives it a contemporary look and complements the molding on the walls.

The molding on this box column gives it a contemporary look and complements the molding on the walls.

table saw
air compressor
pneumatic nail gun
tape measure
carpenter's glue
safety goggles
15 poplar 3/4"x 8"x 8' boards
six poplar 3/4"x 4"x 8' boards
eight poplar 3/4"x 2"x 8' boards
House of Fara MDF base
House of Fara reversible flute
House of Fara oak colonial panel
sandpaper
two paint brushes
two paint rollers
two gallons MAB Paint Genna
pencil

HRIPR-110_ColumnStep_15

Steps:

1. Measure the space for columns (ceiling to floor for height) and determine how wide your columns will be and how many columns you want to make. Using tape measure and level, mark your measurements on a piece of poplar.

2. Set the table saw blade to a 45-degree angle to create miters on the poplar. Measure to determine width of wood. Wearing safety goggles, cut the poplar with table saw. Repeat this process to make four sides of wood that will become the pilaster.

3. For the front wall, we changed the blade on the table saw by putting a fence on it to create two mitered returns on the poplar. Run the piece of poplar through the table saw on the opposite side of the mitered edge. Cut the edges off the poplar with a circular saw.

4. Measure and cut blocks for both ends of the poplar to hold the joined sections together. Working on the back columns, use a strip of carpenter's glue to join the pieces together, then use the pneumatic nailer to secure them.

5. Continue this process to complete the column. Sand the edges.

6. For the front sections, use the two pieces that have two mitered edges as the outside and one piece as the middle. (These do not have the blocks inside to support them.) Use carpenter's glue to hold the two pieces together. Nail the joined pieces in place, and continue to opposite edge.

HRIPR-110_ColumnStep_17CROP

7. Cut down the smaller piece of poplar. The wall will fit in the middle of the opening and be the return for the mitered edge.

8. Install the front finished columns in the room.

9. For the back sections, we glued the backs of the 4' blocks and then put nails in them. Install the back finished columns and put a couple of nails in to hold the column into place along the wall. Measure the completed column to cut the reversible flute on bottom and the MDF base on the top.

10. Measure five equidistant lines down the length of the column to place the colonial panel molding and mark off on column with a pencil. Once you have all your measurements, paint the molding for columns.

11. Cut the molding using the table saw at 45-degree angle to make the mitered cuts. Apply a stream of carpenter's glue on the back of each piece of molding, and attach it to the column at the pre-measured pencil marks. Nail the molding into place.

12. Paint the completed column.

Next Up

How to Build a Climbing Wall

Level up any playroom by creating a DIY climbing wall that's perfect for little adventurers. The editors at HGTV give you the know-how.

How to Install Glass Shower Doors

Here's how to replace your dingy shower curtain with a gorgeous sliding glass shower door yourself.

How to Paint a Deck

All you need is one weekend to give your deck a whole new look and protect it for years to come.

How to Clean a Faucet Head​

A dirty faucet head can affect your water pressure and the flavor of your water. Here's an easy way to keep it clean.

How to Clean a Shower

Here's how you get rid of soap scum and shower grime so that your once-sparkly shower can shine again.

How to Weatherstrip a Door

Replacing the worn weatherstripping on your door is the secret to keeping your home warm in the winter and cool in the summer.

How to Install Garden Lights

Whether you're after that cozy glowing garden look or you simply need to safely traverse your garden after nightfall, here are simple steps for installing garden lighting.

10 Home Projects To Tackle This Summer

Make the most of the long summer days ahead and elevate your casa with home project ideas with Scout & Nimble.

How to Clean a Bathroom Fan

It doesn't take much to keep your bathroom ventilation working well, but it's a spot we all tend to ignore.

How to Clean a Blackstone Griddle

Learn the quick and easy way to clean your Blackstone after cooking, so you can enjoy your food while it's still hot.

Go Shopping

Get product recommendations from HGTV editors, plus can’t-miss sales and deals.

About HGTV

HGTV’s expert editors and writers share home decorating, garden and home improvement ideas, inspiration and advice based on our brand’s 30+ years of expertise and experience. We also give you the latest updates on HGTV shows and stars, cleaning tips and shopping recommendations. Learn more about us and our editorial standards.