How to Install Wainscoting to a Wall

Add an instant touch of class to a room with these step-by-step instructions.

Font
  • A
  • A
  • A

E-mail This Page to Your Friends

x

All fields are required.

Separate multiple e-mail addresses with a comma; Maximum 20 email addresses.

Refresh

Sending E-mail

Sending E-mail

Or Do Not E-mail

Success!

A link to %this page% was e-mailed

Looking for a sure-fire way to create an air of elegance? Check out this wainscoting project.

Materials and Tools:

4-by-8-foot wainscoting panels
¾-inch MDF medium-density fiberboard (MDF)
base molding
chair rail
construction adhesive
2-inch brad nails
table saw
laser level
chalk line
miter saw
pencil
brad nailer
caulk gun
jigsaw
drill

Steps:

1. Remove any baseboard molding around the room.

2. Set a laser level to the desired height of the wainscoting. Measure from the laser line down to where the baseboard will fit, based on the height of the wainscoting boards. Any imperfections in the floor will later be covered by the base molding.

3. Based on these measurements, mark the wall with chalked twine at the point where the top of the MDF baseboard will go.

4. Rip the MDF into strips 5½ inches wide. Cut the strips to length to fit around the base of the room. Wherever the strips meet along the straight portion of the wall, cut scarf joints so the pieces match up to hide the seam. One piece should be cut at a 15-degree angle to the front and the complementary angle on the back. Join pieces in the corners with 45-degree angles. Attach the strips to the wall with 2-inch brad nails.

5. Cut the 4-by-8 sheets of wainscoting in half.

6. If any electrical or cable outlets or phone jacks are exposed, measure and mark the location on the piece of wainscoting to make cutouts. Using a drill with a bit large enough to fit a jigsaw blade, drill a hole on the edge of the area to be removed. Be sure to drill within the mark, and then cut around the marked area with a jigsaw, starting in the drilled hole.

7. Liberally apply construction adhesive to the back of a wainscoting panel and hold up to the wall so the beading runs vertically.

8. Place the wainscoting on to the wall with the bottom resting on the MDF strips that were added at the base. Quickly pull the panels off the wall part of the way so the adhesive becomes stringy and covers a greater area on the back.

9. Quickly tack the wainscoting down with 2-inch brad nails to keep them flat against the wall and prevent them from shifting.

10. Unless the room's perimeter measurement is divisible by 4, trim a wainscoting panel to fill in the smaller gaps.

11. Tack the base molding to the outside of the MDF at the base with 2-inch brad nails. Be sure the molding also has scarf joints to hide the seams.

12. Add a chair rail to the top of the wainscoting using the same scarfing technique as you did for the wainscoting and the molding.

We Recommend...

How to Install Wainscoting

How to Install Wainscoting

Add architectural detail to your home by installing wainscoting.

How to Install Beadboard Wainscoting

How to Install Beadboard Wainscoting

Beadboard wainscoting gives a family room a cozy lake-side feel.

How to Install a Glass-Block Wall

How to Install a Glass-Block Wall

Add some natural light to a room without sacrificing privacy with this project.

Advertisement

HGTV Inspiration Newsletter

Create your unique, personal style with advice and inspiration from HGTV.