How to Make a Concrete Fire Bowl

No room for a fire pit? Make an easy concrete fire bowl that fits in a backyard of any size.

Concrete Fire Bowl

Photo by: Tomas Espinoza/Flynnside Out Productions

Tomas Espinoza/Flynnside Out Productions

Related To:

Materials and Tools

  • quick-mix concrete
  • vegetable oil spray
  • damp rag
  • bowls for forms (one 22" and one 18")
  • drop cloth or plastic sheeting
  • 14" charcoal grate
  • river stones
  • long lighter
  • drill
  • 1/2" masonry bit
  • mixer
  • bucket
  • rubber gloves
  • dust mask
  • goggles
  • mallet
  • orbital sander
  • 220-grit sanding block

Mix Concrete

Prep your area with scrap board or tarps, as mixing concrete can be messy. Wearing gloves, a dust mask and goggles, pour concrete mix and water into a bucket, and mix until you get a pancake batter consistency (Images 1 and 2). You’ll need to work quickly, so the concrete doesn’t set before you pour into the forms.

Prep Forms

The larger bowl will form the fire bowl exterior. Use vegetable oil spray to lubricate the inside of this bowl (Image 1). Then, do the same to the outside of the smaller bowl which will form the shape of the fire bowl’s interior. Spread oil evenly with a rag if needed (Image 2).

Pour Concrete Into Form

With your concrete at the right consistency, quickly and carefully pour the mix until you fill the large bowl about halfway. Then, press the smaller bowl into the mixture in the center. Use light pressure, and push until the concrete mix raises to the desired height (Image 1). Add weights to keep the small bowl in place during the curing process (Image 2).

Release Air Bubbles

To ensure the concrete cures smoothly, release the air bubbles. First, lightly tap the outside of the larger bowl with a mallet, working your way around the bowl (Image 1). Then, using an orbital sander on low, gently vibrate the outside of the larger bowl, spinning the bowl slowly as you go (Image 2). This will help remove any remaining small bubbles.

Allow to Cure

Place the form in a dry area, and allow to cure until fully set. The longer you allow the fire bowl to cure, the stronger it will be. This is important, as it will likely be exposed to extreme shifts in temperature.

Allow Concrete to Cure

Photo by: Tomas Espinoza/Flynnside Out Productions

Tomas Espinoza/Flynnside Out Productions

Remove Forms

Once fully cured, remove the inner bowl first (Image 1), being careful not to chip the fire bowl’s lip. Next, flip the larger form over until the concrete fire bowl releases (Image 2).

Sand Bowl  

Using a 220-grit sanding block, give the fire bowl a light sanding to remove any rough areas. Don’t over sand as this can damage the overall finish of the bowl.

Sand Concrete Bowl

Photo by: Tomas Espinoza/Flynnside Out Productions

Tomas Espinoza/Flynnside Out Productions

Add Drainage

Flip the fire bowl, and drill a hole in the center bottom of the bowl using a 1/2" masonry bit. Remove any dust with a damp rag.

Drill for Drainage

Photo by: Tomas Espinoza/Flynnside Out Productions

Tomas Espinoza/Flynnside Out Productions

Add Finishing Touches

The fire source for this project is really up to you. If you prefer a gel fuel, simply place a few down in the base of the bowl (Remove the lids if you're about to light a fire) (Image 2). Place the barbecue grate into the bowl so that it’s resting against the sides of the bowl and not the cans (Image 2). Spread river stones across the top of the grate until the grate is no longer visible (Image 3). Make sure the stones are larger than the spaces in the grate.

Safety Note: To access gel cans, simply pull up the grate, remove the cans, and take the lids off. Place back in the fire bowl along with the grate and stones. Move stones over, and light with a long lighter.

Concrete Fire Bowl

Photo by: Tomas Espinoza/Flynnside Out Productions

Tomas Espinoza/Flynnside Out Productions

Next Up

How to Install a Shower Tile Wall

Update your bathroom by installing tile in the shower with these step-by-step instructions

How to Make a Vertical Garden With PVC Pipe

Plant a small-space vertical garden using PVC pipe.

How to Build an Outdoor Minibar

Build an outdoor bar complete with a miniature refrigerator, bottle opener and towel hooks.

How to Install a Solar-Panel Security Light

Follow our easy steps to install a solar-panel security light.

How to Clean Rust Off Concrete

Follow these directions to remove an unsightly rust stain from your concrete patio, driveway or garage floor.

How to Drill Into Brick or Concrete

Drilling into tough materials can be challenging, but using the proper equipment takes the effort out of anchoring into brick and concrete.

How to Clean Concrete Countertops

Concrete countertops are known for their strength and durability. Keep them in tip-top condition with just two easy steps.

How Many Bags of Concrete for a Fence Post?

Knowing how deep your fence post needs to be set is key to answering the question. Learn how to set a post and figure out how much concrete you’ll need.

How to Build a Concrete Countertop

Learn how to construct and install a concrete slab countertop for a kitchen island.

How to Build a Fire Pit in an Afternoon

With a short list of materials and just a few hours, you can easily create an inviting fire pit area that will quickly become your new favorite spot in the backyard.

Go Shopping

Get product recommendations from HGTV editors, plus can’t-miss sales and deals.

On TV

Follow Us Everywhere

Join the party! Don't miss HGTV in your favorite social media feeds.