How to Repurpose Mirrored Closet Doors
Step-by-step instructions for creating an updated look
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Don’t like that dated look staring you in the face? Replace those mirrors with a more modern touch in this closet-door project.
Materials and Tools:
3-inch medium-density fiberboard (MDF) strips or scrap wood
heavy-duty panel adhesive
brackets for dowels
weenie roller (a paint roller with a small tubular pad attachment the size and shape of a hot dog) (a standard paint roller can be substituted)
sheer fabric for curtain panels
sewing machine or needle and thread
5/8-inch wooden dowels
5/8-inch nail-gun nails in a color tone that will match your wood
1. Remove mirrored doors from the track and flip over so that the back sides becomes the front sides.
2. Adhere the MDF strips or scrap wood pieces to those new front sides with heavy-duty panel adhesive. Be sure to leave a gap between the bottom piece of MDF or wood and the sides of the frame large enough to fit a 5/8-inch dowel covered in fabric.
3. Use a drill to attach brackets to the inside top portion of your newly mounted inner frame. Note: To avoid the expense of brackets, you can use the end caps of copper tubing and cut out a side section large enough for the dowels to slide through.
4. Use a Skil saw to cut out the midportion of the plywood an inch wider than the MDF frame behind it. Use a paintbrush to apply oil-based stain to the newly created door skin. Finish by applying two coats of water-based polyurethane with a weenie roller.
5. Use a needle and thread or a sewing machine to construct the curtain panels with a finished edge on each side, and finish off by adding rod pockets at the top and the bottom. Be sure to make the panels two to three times wider than the inside of the doors you wish to cover. That ensures that the material can be bunched together for a softly pleated look and that the panels aren’t see-through.
6. Insert a 5/8-inch wooden dowel into the top and bottom of the rod pockets, and fan the panels out evenly.
7. Slip one dowel into the inner bracket of the top of the frame and the other dowel into the gap that’s been left at the bottom of the frame. Nail both dowels into the top and bottom pieces of the frame with a nail gun to further secure the panels.
8. Secure the plywood door skins to the MDF frame with the same heavy-duty panel adhesive, followed by the 5/8-inch nail-gun nails. Shoot the nails at an angle so they don’t puncture the door skins. Place doors back on the sliding track.