How to Clean Walls and Wallpaper
Learn how to remove smudges, smears and fingermarks from your walls with these expert tips.
- Excerpted from Houseworks, by Cynthia Townley Ewer
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Soft with paint or bright with wallpaper, walls frame the life of the household — but too often, they also wear it! Daily living tends to deposit smudges, smears, and fingermarks (especially if there are small children in the household), marring the beauty of walls and woodwork. Painted or papered, keep walls clean and gleaming with these tips for wall cleaning and maintenance.
How to clean painted walls
On your mark, get set, prep! Cleaning painted walls is a big job, so be prepared. Push furniture to the center of the room, and lay down old sheets or canvas drop cloths to catch soapy drips. Avoid plastic tarps; they don't absorb water and become slippery when wet. To protect your hands and to remind you where pictures belong, cover picture nails with a chunk of household sponge.
Assemble your wall-washing tools: lamb's wool duster, white cleaning cloths, a natural sponge (avoid colored sponges, since they can deposit dyes on light-colored walls) and two buckets: one filled with cleaning solution and one filled with clear water for rinsing. Rubber gloves or washing-up gloves protect your hands; be sure to turn up glove cuffs to help contain drips. A step stool makes it easier to get to the high reaches for easy cleaning; tools with handles keep wall cleaning sessions safe.
Ready to Clean
In one bucket, mix a wall-cleaning solution. For normal soil levels, try a mild detergent solution to clean walls that consists of:
- 1 gallon (4 liters) warm water, to which you add
- a good squeeze of liquid dishwashing detergent
For more heavily soiled walls, you'll need a stronger alkali solution, but spot-test any cleaning mixture first to ensure it won't remove or lighten paint. Add all of the following to your bucket and give it a good stir before you start:
- 1 gallon (4 liters) warm water
- 1 cup (250ml) clear nonsudsing ammonia
- 1 cup (250ml) white vinegar
- 1 cup (250ml) washing soda (borax)
The second bucket should hold clean water, to be used for rinsing. Change the water if it starts to look very dirty as you work around the room.
Ditch the Dust
Dust is always easier to remove than mud, so remove any loose dust before bringing moisture into the mix. Circle the room with the lambswool duster, wiping walls and woodwork from the top down. Take the duster outside and spin the handle between your palms to release the dust.
Alternately, use a vacuum cleaner's extension wand and bristle brush head (used for upholstery) to remove dust and cobwebs from walls and woodwork.
Drips are inevitable when washing walls. Should they run down dry, dirty surfaces, they'll dry-and create long muddy stains. Avoid drip issues by washing walls from the bottom up. Yes, you'll drip onto already-cleaned areas, but the solution will be a quick swipe with a sponge, not a tough cleaning job.
Dip the natural sponge into the bucket of cleaning solution, and rub the wall gently to avoid removing paint. Work in small areas, washing and then using the sponge to rinse the area with clear water. Last, blot excess moisture with white cleaning cloths.
Take It to the End
When washing walls, always wash the entire wall, bottom to top and side-to-side. If you need a breather, take it between walls, not in the middle. Stopping the job before you finish the entire wall can cause "wash marks": a wave effect caused by stop-and-go wall washing. Avoid this by washing an entire wall in a single session, using the same type and strength of cleaning solution.
Excerpted from Houseworks, by Cynthia Townley Ewer
Text Copyright © 2006, 2010, Cynthia Townley Ewer, extracts from Houseworks, reproduced with permission from Dorling Kindersley Limited
Learn how to properly clean and repair your gutters with our step-by-step instructions and expert tips.