Veneer Flooring That's Easy to Install
Carter Oosterhouse of Carter Can shows how to install walnut veneer tongue-and-groove flooring.
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Walnut flooring can give any room a rich, solid feel. But the best part is that tongue-and-groove floor installation can be as simple as locking the boards together like a puzzle for a strong, tight seam. Because it's a "floating" floor, there’s no need for staples or glue.
Materials and Tools:
pre-finished walnut veneer flooring (tongue-and-groove type)
1. First determine which direction you want the flooring to run. Usually flooring is installed so it runs the length of the room for aesthetic purposes, but it depends on personal taste.
2. Remove any baseboards as the flooring needs to be installed close to the wall.
3. Place the underlayment on top of the existing floor or the subfloor, as this will help reduce moisture and squeaking. Staple the underlayment into place so it won’t shift.
4. Start at the corner of the room and place the first board with the tongue facing toward the wall. Be sure to leave a gap of about half-an-inch so the floor has room to expand and contract.
5. Place the second board next to the first so the shorter ends touch and pull the second piece as close as possible.
6. For a tight fit, grab a small scrap piece of the flooring and fit it into the grooves of the last piece. Place a block on the end of the scrap piece and knock it with a mallet a few times until it locks into place (figure B). Do not try to knock the wood directly, as it may damage the edge. If a piece is damaged, save it to use later as an end piece.
7. Continue laying down the flooring in this manner. When you get to the end next to a wall, mark with a pencil how much flooring remains and cut down the piece to the appropriate size.
8. In order to lock the end piece into place, try using a smaller scrap piece of flooring. If there isn’t enough room in the gap to fit a tool, place a pry bar and pull it into place with the mallet (figure C).
9. Continue laying down each floorboard until the room is complete. For any irregular corners, try cutting the flooring with a jigsaw. It’s best not to have the seams line up, so stagger the rows.
10. Many types of flooring comes pre-finished, but if you choose an unfinished floor, be sure to sand it down, stain it and finish it. Finally, reinstall the baseboards when all flooring is down.
Renee and Biff have raised four kids together, and at some point or another, each has called the guesthouse their home. Now,...(6 photos)
Host Kenneth Brown creates a hip, contemporary space for entertaining and relaxing.(8 photos)