Installing a Retractable Cloth Awning

A cloth awning looks great and helps your home keep its cool.

Font
  • A
  • A
  • A

E-mail This Page to Your Friends

x

All fields are required.

Separate multiple e-mail addresses with a comma; Maximum 20 email addresses.

Refresh

Sending E-mail

Sending E-mail

Or Do Not E-mail

Success!

A link to %this page% was e-mailed

Retractable awnings can be used to shade a house and cover open patios, windows or entryways. And by providing shade, they protect windows and doors from the power of the sun.

This project costs about $1,500 and takes a day to do. The cost of this project can vary greatly with the size of the awning. Be sure to use the manufacturer’s instructions as a guideline.

Materials and Tools:

retractable cloth awning kit
brackets (included in kit)
2 ladders
utility knife
measuring tape
pencil
2-foot level
drill
3" galvanized lag screws with washers
socket wrench
chalk line

Steps:

1. Unwrap the plastic sheet covering the awning and allow the awning to rest on the plastic. Make sure the awning is resting so that the front faces out and the valance is facing forward and hanging down. Set the brackets to the side.

2. Measure the length of the awning and transfer the measurements to the wall where the awning will be mounted. Write an "E" to locate where both ends will be. Measure for the hardware locations on the awning and transfer those dimensions as well, writing a “B” where the mounting brackets will be located. All four brackets will be evenly spaced for maximum support.

3. Position the first bracket and mark the drill holes with a pencil. Be sure to check the pencil marks for plumb with a 2-foot level.

4. Drill through the marked drill point to make sure there’s a stud, band or top plate that can act as a sturdy anchor. Once this has been determined, continue to mark both bracket holes, use a 2-foot level to draw a line through both marks, drill pilot holes, and attach the brackets with 3-inch galvanized lag screws and washers with a socket wrench.

Tip: Don't overtighten the lag screws, because they will strip. Also, install the outside brackets first, pop a chalk line between the two to determine level, and then install the inside brackets.

5. With the four brackets in place, carefully lift the awning and set it in place. The ends of the awning should match up with the "E" marks.

6. Close the brackets by slightly lifting the front of the awning and then sliding the bracket cover over the square tube of the awning. Then attach the hardware to clamp the bracket shut. Use a socket wrench to tighten the hardware. Repeat this procedure for all brackets.

7. Remove the safety bands from the arms and open the awning using the crank. Check the height and level of the front bar. If you aren’t satisfied, adjust the pitch and angle of each arm separately. You can use an alum wrench to adjust the angle of the arm — turning clockwise will raise the arm, counterclockwise will lower it. Be sure to adjust both arms to the height you want and to check that the front bar is level.

We Recommend...

Installing a Tile Floor

Installing a Tile Floor

A stone or ceramic tile floor in the kitchen is durable and adds visual drama.

Build a Movable Storage Seat

Build a Movable Storage Seat

Mobilize your storage options with this simple project.

Buying a Fixer-Upper

Buying a Fixer-Upper

These prospective parents consider three homes in various states of repair.

(video 04:33)
Advertisement

HGTV Inspiration Newsletter

Create your unique, personal style with advice and inspiration from HGTV.