Contemporary TreeMaterials:
fiber density board
large carpenter's compass
jigsaw
palm sander
tack cloth
drill with 1/4" spade bit
galvanized flowerpot
large heavy rocks
scrap lumber
1/2" galvanized plumber's pipe
floor brackets
1/2" wood screws
latex metallic silver paint
ornament hooks
decorations (ornaments, garland, fake snow, tinsel, etc.)
Steps:
1. To make the tiers, use a compass (or a string attached to a pencil) to trace circles onto the board (the tiers measure 30, 24, 20 and 12 inches in diameter), and then cut each out with a jigsaw, staying as close to the line as possible. Sand the edges smooth with a palm sander and remove the dust with a tack cloth or damp rag.
2. To support the tree, cut a board to nest just below the top of the pot. Put three or four large rocks in the pot, and then put the board on top.
3. Attach a floor bracket to the top center of the flower pot board using screws, and then secure a 12-inch piece of pipe into it. Attach a floor bracket to the center of both sides of each disk. Screw the 30-inch disk onto the flower pot pipe; add a 12-inch length of pipe, and then another disk until the shortest disk is secure. Attach an eight-inch pipe to the top disk to keep in scale with the tree.