Transfer Pendant

Materials:

The Ranger Melting Pot
Clear Ultra Thick Embossing Enamel (UTEE)
UTEE F-L-E-X
various small metal cookie cutters
non-stick craft sheet
Perfect Medium
Perfect Pearls dry mica powder
small soft brush
Kool Toolz spatula
magazine pictures
wood-burning tool
deep dish of warm water

Tip: Pick magazine images with bright color or good contrast, as they will show up the best when transferred.

1. Fill the Melting Pot to the MAX line with clear UTEE and add in 1/2 to 3/4 scoop of F-L-E-X. Turn heat to 340 F degrees, cover and allow to fully melt (figure A).

2. Stir everything gently once it is all melted. Stirring too vigorously causes air pockets.

3. Slowly pour the melted UTEE over the magazine image you want to transfer and immediately place a cookie cutter into the UTEE, over the image. Allow the UTEE to harden and cool slightly (figure B).

4. Press down on the cookie cutter so the magazine shape encased in UTEE pops out.

5. Place the shape into warm water and begin peeling away the paper backing (figure C). Eventually it will all come off, leaving only the transparency of the magazine image on the UTEE.

6. Dry off piece. Rub the back with Perfect Medium directly from the pad.

7. Use a small brush to apply Perfect Pearls (gold or kiwi) to the backside. It will stick to the Perfect Medium (figure D). Wipe excess residue off with a soft rag.

8. Use a wood-burning tip to pierce a hole through the UTEE; add jump rings and a cord to wear (figure E).