Click to Print
HGTV.com

http://www.hgtv.com/handmade/how-to-make-a-wood-pallet-dog-bed/index.html

How to Make a Wood Pallet Dog Bed

Give your furry friend a comfortable spot to sleep using reclaimed shipping wood pallets.

Brian Patrick Flynn, Decor Demon

Materials Needed:

  • wooden shipping pallets
  • tape measure
  • nail puller
  • hammer
  • 1 1/2" finish screws
  • stainless steel finish nails
  • chop saw
  • carpenter's pencil
  • drill

Dismantle Pallets

Gather a group of used wooden shipping pallets (Image 1). Using a hammer or nail puller, remove each plank of wood from the pallet base (Image 2), then dismantle the base.

Choose Best Pieces

Lay all pieces of wood out on a flat, level surface. Based on your specific shipping pallet and the intended size of your dog bed, choose which pieces are the best fit for the two sides, the rear, the front fascia and the base. Tip: A good-sized dog bed for small and medium dogs is 12 to 16 inches, and 14 to 18 inches for larger dogs.

Measure and Cut Boards

Measure and mark side boards using measuring tape and a carpenter's pencil. Cut them to 24-inch lengths with a circular saw. Measure and mark the rear and bottom boards using measuring tape and a carpenter's pencil, and cut to a 36-inch length with a circular saw. These boards will be the rear panel and bottom planks.

Measure and Cut Structural Pieces

To create structural pieces, measure and mark 1 1/2-inch strips using measuring tape and a carpenter's pencil, and cut with a circular saw (Images 1 and 2). Next, use a circular saw to cut six pieces of wood the same length as the desired overall height.

Attach Structural Pieces

Lay out rear panel boards on a flat, level surface, and attach structural pieces on each end with finish nails or screws using a drill or hammer (Image 1). Lay out side panel boards on a flat, level surface, and attach structural pieces on each end (Image 2).

Attach Side and Rear Panels

Attach side panels to each end of the rear panels with finish nails or screws using a drill or hammer.

Cut and Attach Fascia Board

Measure and mark side boards using measuring tape and a carpenter's pencil, then cut front fascia board to length of the front edge from side to side. Install front fascia to side panels with finish nails or screws using a drill or hammer.

Install Base Planks

Attach planks to the base's underside with finish nails or screws using a drill or hammer. Tip: Make sure the planks sit flush, or the dog bed may appear crooked.

Sand Edges

Use an orbital sander or sanding block to smooth out the rough edges of each panel (Image 1). Add cushions (Image 2).

Advertisement will not be printed