Give everyday dining chairs a stylish makeover with easy-to-create linen slipcovers with flirty ruffled skirts. Slipcovers are a great way to disguise mismatched seating or give dated chairs a quick update.Marian Parsons, Mustard Seed Interiors
Prewash fabric and iron if necessary. Drape fabric over chair and use sharp scissors to cut a piece for the seat and both sides of chair back. Be sure to leave several inches of overhang when cutting these pieces, so there is plenty of fabric to work with.
A slipcover is assembled or "pin fitted" inside out. If using a fabric with a clear right side, make sure right side is facing in toward the chair. Starting from the top of the chair back, pin front and back pieces together. Pin along the back line of the chair. It's best to pin the entire top, then alternate pinning a few inches down each side to prevent gaping in the back (Image 1). Put a couple of pleats where the chair back curves (Image 2). Once pinned, make sure fabric lays smooth and is fitted but not tight (Image 3). It should slide off the chair back with little resistance. Cut off excess fabric with sharp scissors (Image 4). Remove from chair and sew along pin line. Remove pins and return slipcover to chair (still inside out).
Position fabric piece over chair seat, and line it up with the fabric on the chair back. Pinch right sides of fabric together where they meet and pin in place. Raw edges should face the same direction and be visible. Cut any excess fabric. Remove slipcover, sew along pin line and remove pins.
Use a clear quilting ruler to mark off 6-inch-wide strips of fabric (Image 1). When sewn together, they should be about twice the length of the chair seat perimeter. Place right sides of two fabric strips together and sew end-to-end (Image 2). Make sure raw edges are facing the same direction. Repeat with a third strip if necessary. Once there is one long strip of fabric, hem one edge by folding it under 1/4-inch (Image 3) then again 1/2-inch and sew along fold. Tip: To make the hem super sharp, iron the folds and pin down prior to sewing.
Return slipcover to chair, still positioned inside out. Start at center chair front and pin center point of the skirt top to the slipcover seat. Make sure raw edges are pointing in the same direction. Pinch skirt fabric with fingers to pleat and pin in place, following the lines of the chair seat. Continue around the skirt, pleating and pinning (Image 1). Pin edges together where skirt ends meet (Image 2). Trim excess fabric and sew skirt and seam (Image 3). Remove pins then iron slipcover, especially the skirt, so it lies flat. Wash and iron as needed. Tip: Add piping along skirt and chair back or ribbon ties or buttons along the back to further customize your slipcover.