Looking for a new pumpkin-carving technique? Requiring just two different-sized drill bits, this sculptural and intricate design is easier to create than you may think.Layla Palmer, The Lettered Cottage
Place pumpkin on several layers of newspaper. Using a kitchen knife or pumpkin saw, cut a large hole in the pumpkin's bottom. Use a serving spoon to remove all pumpkin flesh and seeds from inside.
Tip: Save the seeds to toast later for a healthy snack.
Attach a piece of painter's tape around the center of the pumpkin. Apply another row of painter's tape approximately 2 inches above the first piece of painter's tape.
Use a large drill bit to drill holes into the pumpkin just under the top piece of painter's tape. Drill another row of large holes all the way around the pumpkin, just above the bottom piece of painter's tape. Remove both pieces of tape and drill a third row of large holes directly above the top row of holes.
Replace the large drill bit with a much smaller one and proceed to drill smaller holes in between and above each of the large ones, all the way around the pumpkin. Drill one last row of small holes below the bottom row of large ones. The smaller holes should fall directly in between and above or below each of the larger holes.
Use a paper towel and Q-tips to remove excess pumpkin flesh and skin from drilled holes, then place the pumpkin over the top of a lit or LED votive candle.