Transform an ordinary entrance into an elegant archway with these step-by-step instructions.
Once found only in older homes, archways add instant character to a home and are easy to install. This two-day project shows you how to do it.
Materials and Tools:
arched-doorway kit (two fluted columns and one arch; see step 3 below for buying instructions)
2-by-4-inch lumber (scrap-type wood for corner blocks)
1¼-inch drywall screws
joint compound, tray and broad knife
2. To remove the door casing, score the caulking between the casing and the drywall around the entire perimeter. Using a pry bar, loosen and remove the entire casing and pull it away from the wall. With a pry bar and a putty knife, carefully remove the baseboards. Use a claw hammer to remove any protruding nails.
3. Take exact measurements of the opening. Measure from one side of the opening to the other and from the floor to the top of the opening. Also measure the thickness of the jamb. Take these measurements to a home-center store and select an arched-doorway kit.
4. Dry-fit the archway, making sure it's centered in the opening, and make marks on the drywall where the arch crosses the wall. After removing the trim, use the marks to measure for 2-by-4 blocking, and make the cuts with a circular saw.
5. Install the blocks in the corners-one each on the side jambs and the others on the top jamb¾with a drill and screws, and install the cross pieces. These pieces of blocking will be used for attaching drywall. When placing the archway without the new drywall, there would be openings in each corner.
6. Cut four pieces of drywall to the approximate size of the corners. Attach the panels of drywall to the corners with screws. To trim the drywall to the proper angle, score and pop it loose with a utility knife along the diagonal block.
7. Using a broad knife, spread joint compound along the entire length of each joint, covering all seams and holes. Next, press paper tape into the wet joint compound and smooth the tape with the broad knife. Apply a second layer of joint compound over the tape and smooth with the knife. Do this for both corners. Allow to dry.
8. Sand, prime and paint all three kit pieces.
10. Permanently attach the columns to the wall jambs by pre-drilling pilot holes along the edge of the column and filling the holes with eightpenny nails. Set each of the holes with a nail set and fill with spackle. Now is a good time to caulk any cracks if necessary. Install the decorative top cap with one finishing nail.
11. Reattach baseboards if necessary, and touch up wall paint.