Add extra shelves to a console table to create a buffet with plenty of dining room storage.Layla Palmer, the Lettered Cottage
Any console table with extra long legs that can be painted will do.
Using a measuring tape, determine the distances between all four of the table's legs and write them down on a sheet of paper.
To create the first shelf, draw four lines, in the shape of a rectangle, that equal the length of the measurements in the previous step onto a sheet of smooth, paint-grade plywood.
Put on a ventilation mask and a pair of safety goggles. Use a circular saw to carefully cut out the first shelf.
Measure one inch in from each direction on each corner of the shelf and use a pencil to connect the dots.
Cut notches in each corner of the shelf by using a jigsaw to follow the lines drawn in the previous step.
Sand each notch with an electric hand sander or a sanding block wrapped in 80-grit sandpaper.
Check to make sure the first shelf fits properly, and assuming it does, repeat steps for making it to create the second shelf.
Once the second shelf is cut and the corners have been sanded, check to make sure it fits properly below the first shelf.
Use a nail gun and small nails to secure both shelves to the each leg of the console table. Shoot each nail in at an angle so that it goes through both the shelf and the table leg. Tip: Make sure the shelves are level before securing them to each leg.
Apply one coat of water-based primer, then paint both shelves with two coats of semi-gloss, latex paint and allow to dry for 24 hours before placing anything on them.
If the console table has drawers that aren't functioning as well as they should, consider removing them and using baskets in their place.
Apply one coast of water-based primer, then paint the inside of each drawer opening with two coats of semi-gloss latex paint and allow to dry for 24 hours.
Measure each shelf and drawer opening to determine the desired basket sizes. When the paint has fully cured, slide each basket into place.