A beautiful wildlife pond will attract a whole host of beneficial animals, birds and insects. Make one with sloping sides, to allow easy access for creatures to come and go, and leafy edges that offer habitat and cover.
When to Start: Late winter or early spring
At Its Best: Spring to early fall
Time to Complete: 2-3 days
Using a hose, mark out the pond with sweeping curves for a natural effect. Calculate the area of liner you will need by adding twice the total depth (D), plus 18 inches extra, to the length (L). Then add twice the depth (D), plus 18 inches extra, to the width (W), and multiply the two answers (see also Step 2 below): (2xD + 18in + L) x (2xD + 18in. + W).
Dig out the whole area of the pond to a depth of 18 inches, and angle the sides so that they slope slightly. Leave a 12- to 18-inch-wide shelf around the sides at this depth. Then dig out a central area 3 feet deep, and an adjacent area, about 30 inches deep, creating two deeper areas to keep plants and wildlife frost-free in winter.
It's essential that the top edges of the pond are level all the way round, or water will drain out unevenly. Place a level on a straight plank of wood and test the level in six or seven different places, building up or removing soil as necessary.
Smooth the edges, and remove large or sharp stones from the sides and base. Line the pond with old carpet or a special pond underlay. Do not use sand because it falls away from the sides and will fill up the hole.
Center the liner over the hole and push it down in the middle, allowing pleats to form against the sides and base. Fill the deepest part with water; the weight will pull the liner into place.
Fold the liner in neat pleats over the shelf and top edges, and check that it's bedded into the bottom of the pond. Top up with more water, which will force the liner against the shelf and sides.
As you fill the pond, move around so that the liner is pulled evenly into the hole. When the pond is full, trim the liner with a sharp knife, leaving up to 18 inches excess around the edges.
You can lay sod up to the edges, leaving 10 inches of excess liner and butting the sod pieces up to it. Or add stones by mortaring them onto the liner, making sure no cement falls in the water in the process.
When positioning the stones, make sure that they don't overhang the edge by more than 2 inches. This will prevent them from tipping up and both you and the stones falling into the water when you walk on the edge.
Place rocks in the water but protect the liner from damage by placing them on cushions of folded plastic sacks or spare rolled-up liner. Ensure the rocks are stable, but don't mortar them in. The pond is now ready to plant. Use the shelves around the sides for marginal plants, and the deeper areas for submerged aquatics, such as water lilies.
There are four main types of pond plants — deep-water aquatics, oxygenators, marginals and bog plants. Water lilies are deep-water aquatics and sit on the bottom of the pond, although some will grow in shallow water. Check the depth required on the label (measured from the pot surface) and
raise them up on bricks as required.
Oxygenators are essential plants that help keep the water clear. Marginals, such as the marsh marigold (Image 1), prefer the shallows around the edge of the pond, and will be happiest on the shelf (see Step 2). Site bog plants in the damp area around the pond — not in the water.
Excerpted from How to Grow Practically Everything
© 2010 Dorling Kindersley Limited