How to Make Spiral Copper Magnets

Add a classy touch to your refrigerator door with these whimsical copper magnets.

Font
  • A
  • A
  • A

E-mail This Page to Your Friends

x

All fields are required.

Separate multiple e-mail addresses with a comma; Maximum 20 email addresses.

Refresh

Sending E-mail

Sending E-mail

Or Do Not E-mail

Success!

A link to %this page% was e-mailed

Materials and Tools:

16-gauge copper wire
silver and gold beads
needle-nose pliers
round-nose pliers
flat pliers
chain-forming pliers
wire clippers
220-grit sandpaper
steel wool or abrasive pad (without added cleaning agents)
liver of sulfur in heated slow cooker
large nail
dime-size magnet
epoxy glue

Steps:

1. Cut copper wire in two 6-inch lengths. Sand the ends smooth.

2. Make a small loop in one of the wires with round-nose pliers.

3. Switch to the flat pliers and wind the wire into a spiral by grabbing the loop and turning it in half-turns, repositioning the pliers every half-turn to keep them straight in your hand.

4. At the end of the spiral, grasp the wire with the round pliers again and make the same type of small loop. This will connect to the coil that hangs down.

5. Wrap the copper wire 10 times around a large nail, forming a spring.

6. Form a small loop at both ends of the spiral with round pliers.

7. Twist open the loops to join the spiral and the coil with chain-forming pliers.

8. Grasp each end of the coil with pliers and stretch the coil.

9. Dip the spiral piece into heated liver-of-sulfur solution, rinse and remove excess color with steel wool.

10. Apply a pea-size dot of epoxy to the back of the spiral to attach the magnet.

11. Add a silver bead and a gold bead to the bottom of the coil.

12. Let the glue dry for two hours before you attach the magnet to a refrigerator. Caution: The magnet may form a permanent bond to the refrigerator if not fully dry.

We Recommend...

How to Make a Copper Fireplace Screen

How to Make a Copper Fireplace Screen

Punch designs into a copper panel and attach a mahogany frame with this project.

How to Make Magnets From Old License Plates

How to Make Magnets From Old License Plates

Break out the tin snips and learn how to repurpose colorful old license plates into handy magnets for your fridge or message...

How to Design a Copper Heart Pendant

How to Design a Copper Heart Pendant

Create an antique-style necklace from copper and wire with these simple instructions.

Advertisement

HGTV Inspiration Newsletter

Create your unique, personal style with advice and inspiration from HGTV.