How to Make a Papier Mache Fish

This comical papier mache fish is inexpensive to make and adds whimsy to party decor.

Font
  • A
  • A
  • A

E-mail This Page to Your Friends

x

All fields are required.

Separate multiple e-mail addresses with a comma; Maximum 20 email addresses.

Refresh

Sending E-mail

Sending E-mail

Or Do Not E-mail

Success!

A link to %this page% was e-mailed

Materials and Tools:

balloons
wallpaper paste
newsprint cut into 1" x 5" to 10" strips
industrial brown paper towels
plastic cocktail cups (one for each fish)
mixing bowl
water
manila folder
spray paint
acrylic paint
size #4 or #5 paintbrush (other sizes as desired)
tacky glue
grommets
grommet punch
fishing leader
sequins
yarns
rhinestones
buttons

Steps:

Day 1

1. Blow up a balloon to the desired size and knot the end.

2. Pour a small amount of wallpaper paste into a bowl. To make three fish, use 1/4 cup of paste.

3. Slowly add warm water to the paste. Mix the paste to the consistency of pudding.

4. Dip the newspaper strips one at a time into the bowl of paste. Do not fully submerge or soak them, as they will start to fall apart if too saturated. Squeeze the strips between two fingers to remove excess paste and lumps as you remove them from the bowl.

5. Wrap the wet paper strips around the balloon in crisscrossing patterns for strength. Apply a couple of layers over the knot where you tied the balloon off.

6. Rest the fish on a plastic cup as you prepare the next strip.

7. Continue attaching strips until the entire balloon is covered and there are no thin areas or spaces exposed. Smooth out any bumps or wrinkles and remove any excess paste with your hands.

8. Place the fish (on the cup) on the floor near a heater to dry overnight. It may take a day or two to completely dry depending on the humidity in the air. 

9. Check the balloon the following morning and rotate the fish's position on the cup. The section of the balloon that is in the cup tends to dry a bit slower and will need to be exposed to dry thoroughly.

Day 2 or 3 (depending on dry time)

10. Design fins and cut them out of a recycled manila folder. Test the fit of each fin on the curve of the balloon.

11. Mix up a bowl of wallpaper paste as described above.

12. Cut newspaper strips 1/2" x 3" to 6" long.

13. Dip the newspaper strips in the wallpaper paste and attach the fins to the balloon. Start with the tail fin and secure each fin in place. Cover the entire fin with newspaper strips.

14. Put extra support strips at the base of each fin similar to a hinge to add strength. Use the cup to balance the fish so it doesn't roll onto its newly added fins. The fins will be extremely fragile while they are wet.

15. Wad up newspaper into 1-inch balls and attach them to the face of the fish for eyes and lips. Use one ball for each eye and two balls stacked on top of each other for the lips.

16. Place the fish in the plastic cup and let it dry near a heat source overnight.

« Previous12

We Recommend...

How to Make a Papier Mache Dog Sculpture

How to Make a Papier Mache Dog Sculpture

Create this Rottweiler dog sculpture with papier mache strips plastered onto wire.

How to Make a Papier Mache Bowl With Leaves

How to Make a Papier Mache Bowl With Leaves

Cover the back of a bowl with newspaper strips and spackle, and use paint and leaves to create a decorative piece.

How to Make a Paper Map Basket

How to Make a Paper Map Basket

Create a recycled, eco-friendly basket from old paper maps.

Advertisement

HGTV Inspiration Newsletter

Create your unique, personal style with advice and inspiration from HGTV.