How to Make a Hawaiian Flower Pop-Up Greeting Card

Make a tropical-themed greeting card with a 3D surprise hidden inside.

Font
  • A
  • A
  • A

E-mail This Page to Your Friends

x

All fields are required.

Separate multiple e-mail addresses with a comma; Maximum 20 email addresses.

Refresh

Sending E-mail

Sending E-mail

Or Do Not E-mail

Success!

A link to %this page% was e-mailed

Materials and Tools:

2 pieces of 6 1/2" x 10" card stock
5 1/2" x 8 1/2" card stock
6" x 4 1/2" colored vellum
scoring tool
craft knife
ruler
scissors
glue stick or double stick tape
stamp pads in tropical colors
Museum of Modern Rubber stamps:
J-1068 Jumpin' Jack Tab
M-1050 Hibiscus
M-1053 Monstera
J-1056 Creeper
D-1058 Welcome To Paradise
K-1052 Orchid
F-1054 Plumeria
A-1057 Fat Flower

Steps:

1. Score one piece of 6 1/2" x 10" card stock in half. This will be the outer piece.

2. Stamp the card front.

3. Stamp more flowers and the saying "Welcome to Paradise" onto the vellum. Apply the vellum to the card front.

4. On the second 6 1/2" x 10" piece of card stock, stamp an overall pattern of flowers and leaves. This will be the inside of the card.

5. Flip over and mark a line down the center. Score on the line.

6. Mark two horizontal guidelines 1-1/2 inches and 3 inches down from the top. Mark the Jumpin' Jack Tab onto the card stock. Score the two lower angled lines.

7. Use a craft knife to cut the lower line and the three-segment upper line.

8. On the remaining piece of card stock, stamp the hibiscus image two times and cut both out.

9. Flip over and mark a vertical center line on each flower. Make a mark at the halfway point on each center line. Cut a slot on the upper half of the line of one flower and the lower half of the line of the other flower. Slide the two pieces together and line the center slots up straight.

10. Apply a little glue or double stick tape to either side of the Jumpin' Jack Tab. Position the hibiscus (with both pieces intersected) onto the tab. The center lines of the hibiscus should line up directly over the center fold line of the card. The bottom edge of the hibiscus will fall below the lower cut line of the tab. Ensure that the sides of the hibiscus do not overlap the lower angled fold lines.

11. Slide the inside card piece into the outer card piece. Open the front cover and glue the two layers together.

12. Flip the card over, open the back cover and glue those two layers together. Be sure not to get any glue in the tab area.

We Recommend...

How to Make a Silk Screen Card Set

How to Make a Silk Screen Card Set

Design your own silk screen greeting cards using transparency film.

How to Make a Bird and Branch Holiday Card

How to Make a Bird and Branch Holiday Card

A pinecone adds texture and a sophisticated natural touch to this charming handmade holiday card.

How to Make a Personalized Place Card

How to Make a Personalized Place Card

Make your own personalized place cards by following these steps.

Advertisement

HGTV Inspiration Newsletter

Create your unique, personal style with advice and inspiration from HGTV.