Materials Needed:

• corks
• 1" automotive expansion plugs (size may vary depending on the cork size)
• 1/4" diameter wooden dowel
• 2-part epoxy
• 1/4" drill bit

• assortment of found objects
• hammer
• drill
• pliers or vise
• awl or punch

Prepare Expansion Plugs

Mark center of expansion cap with awl then drill through center of expansion cap using 1/4-inch drill bit.

Drill Cork

Drill a 3/4-inch deep hole in the center of the cork using 1/4-inch drill bit. Tip: Placing expansion plug on the cork before drilling will ensure proper alignment. Use tape wrapped around your drill bit to give you a measured stopping point.

Enlarge Photo+Shrink Photo-

Cut Dowel

Cut 1/4-inch diameter dowel to 1-1/2-inch length.

Enlarge Photo+Shrink Photo-