Brass Pyramid Pendant Necklace
This precious pyramid-shaped pendant holds a marble that seems to float inside.
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Jef McGreevy of Reisterstown, Md., demonstrates how to make a pyramid-shaped brass pendant with a marble that seems to float inside.
Materials and Tools:
1. Cut three pieces of brass wire for the bottom of the pyramid pendant.
2. Sand all the edges at a 45-degree angle on a belt sander. The wire will heat up, so wear gloves if necessary.
3. Fit the pieces together into a triangle shape and solder, applying flux to the ends and firing with a butane torch.
4. Cut three more pieces of brass wire for the vertical posts of the pyramid.
5. Sand all the edges at a 60-degree angle on a belt sander.
6. Solder two vertical posts at a 60-degree angle, applying flux to the ends and firing with a butane torch. Hold the brass wire with tweezers to prevent burning your fingers.
7. Place the marble in the bottom part of the pyramid.
8. Solder the remaining vertical post after applying flux to the joint.
9. Sand the top flat.
10. Cut and bend a loop from the brass wire for the cord. Flatten the brass by hammering the end. Bend it around needle-nose pliers.
11. Solder the loop on the top of the pyramid.
12. Thread the cord for the necklace through the loop. Tie the brass pyramid pendant around your neck.
Use copper wire to create a beaded bracelet featuring three craft coins.
A glass artist shows how to create this glow-in-the-dark craft for a perfect Halloween hair accessory.
Make an elegant, daisy flower necklace pendant using sterling silver and semiprecious gems.