Install Tongue-and-Groove Wood Floors on a Ceiling
Add architectural interest to a flat drywall ceiling with tongue-and-groove wood floors.
E-mail This Page to Your Friendsx
A link to %this page% was e-mailed
Check Boxes of Flooring and Measure Thickness
Open boxes of wood flooring, then use a measuring tape to determine the thickness of each plank. Although planks 1/2” and smaller should sit nicely against molding, planks thicker than 1/2” may leave a gap that will require installing small decorative trim such as molding or 1/4” round.
Tip: Do not use flooring that is coated with rubber or padding due to heaviness and added thickness.
Begin installation of wood flooring by starting in corner and paying attention as to which side of each plank is the "installation" side. Also know that each plank will have two different ends. One of the ends is the side that is installed first, and the other end is the side that locks into the "installed" side. Determine the correct side and using a full plank, attach with angled flooring nailer properly placed against the edge of each plank.
Tip: Nailer will have a depth guide attached to the "foot" side of it, which properly angles the gun. Squeeze trigger and nail should go into the flooring inside the joining groove and not through the finished side of the floor.
Use the strike block and rubber mallet to maneuver the pieces together for a snug fit. Be certain the pieces are lined up with each other and not crooked; otherwise the next length of flooring that is attached will have gaps and fit improperly, resulting in misalignment throughout the entire project.
Cut and Stagger
As each run comes into contact with the opposite end of each wall, the very last plank will need to be cut to size with a chop saw. Once cut, use the leftover pieces to create a staggered effect for the very next run of wood.
Add organic color, pattern and texture to a lackluster ceiling with grass-cloth wall covering.